how to install analog to digital converter box

lf SmartCraft System View is being used, a junction box and harness adaptor will be required. lf SmartCraft System View is not being used, plug 10 pin CAN data connection on AGI harness directly into 10 pin CAN data connection on command module harness.ī. Connect 10 pin CAN data harness connection on command module harness to AGI harness.Ī.Plug 14 pin AGI harness connection into AGI module.

The AGI system can support 10 System Link gauges per helm, 2 helms maximum.

Connect any SmartCraft System Link gauges to 3 pin System Link connection.

Secure connections per gauge manufacturers’ specifications.

Route and connect ground wire from analog gauges to a common ground.

Route and connect wire from key switched 12 volt positive power source to analog gauges.

Secure connections per gauge manufacturers’ specifications.Īnalog Gauge Type AGI Harness Wire Color Tachometer Gray Oil Pressure/Oil Level Blue Water Temperature Tan Trim Positions BrownAtVhite Fuel Level Pink/Black

Refer to the following table for AGI harness wire color/analog gauge sender input connections.

With screws and washers supplied in kit, mount the AGI module securely under dash or helm in close proximity to gauges being used.Route and secure all wires and harnesses away from hot or moving parts. IMPORTANT: Mount AGI module with wires coming out of potting facing downward to prevent moisture from collecting at base of wires and wicking into module.

How to install analog to digital converter box